 |
 |
 |
| |
 |
|
 |
 |
|
1 |
Tension Band -
Brace Bands |
Shall be 1/8 x 1" pressed steel fastened with 3/8 x 1 1/2" carriage bolt. |
|
2 |
Tension Bars |
shall be 1/4" thick by 3/4" wide for 1 1/2" - 2" mesh wire. 1/8" thick x 1/2" wide for smaller mesh sizes. |
|
3 |
Post Caps |
shall be malleable iron dome shaped for 1 5/8" - 2" size and acorn shaped for 2 1/2", 3", 3 1/2" - 4", 6 5/8". |
|
4 |
Loop Caps |
shall be malleable iron rounded on top. |
|
5 |
Extension Arms |
shall be provided to all posts when barbed wire and razor ribbon is requested. Arms shall withstand a weight of 200 lbs., available in three strands and six strands. |
|
6 |
Barbed Wire |
(when specified) - shall be of 9 GA strand with 4 point aluminum barbs spaced 3" apart. |
|
7 |
Sleeves |
for top rail shall be malleable iron by 7". |
|
8 |
Truss Braces |
shall be 1 5/8" OD SK 40 pipe for heights up to 9' with 1/2" truss rod, malleable turnbuckle and brace rail ends. |
|
9 |
End Clamps,
Boulevards &
Corner Boulevards |
used to attach top-middle-bottom rail to posts shall be 3/16" thick made of pressed steel and fastened with a 3/8 x 3 bolt. |
|
10 |
Tension Wire |
(For fences without top rail or in lieu of the bottom rail) shall be crimped 6 gauge (.192") thermally extruded wire, and shall be fastened to the fabric at intervals of 24" with vinyl coated hog rings. |
|
11 |
Ties |
must be provided and fastened at intervals of 24" for rails and all line posts double wrapped and made of 13 gauge (.091") 7 mil bonded wire. |
|
12 |
Razor Ribbon |
18" - 24" - 30" with a spacing no greater than 12" shall be vinyl coated to match the color of fabric and frame work |
|
|
|
1 |
Gates |
all gates shall have an internal locking device, they shall be made of 1 1/2" ID pipe (2.72 lb./ft) welded prior to a fluid bed vinyl submersion. Gate corners welded after vinyl coating not permitted. |
|
2 |
Hinges |
shall be offset type malleable iron.
3x2 hinge shall weigh 21 lbs.
4x2 hinge shall weigh 23 lbs.
6x2 hinge shall weigh 28 lbs.
8x2 hinge shall weigh 34 lbs. |
|
3 |
Locking Device |
all gate leaves shall have an internal locking device. |
|
4 |
A Center Gate |
stop shall be installed for each leaf at a depth of one foot in ground. |
|
5 |
Hold Backs |
shall be installed for each leaf, thus preventing self-closing of gate when in open position. |
|
|
 |
|
 |
| |
|
|
|
|
|
|
|
|
|
American Fence, Inc.
(610) 437-1944
2738 Eberhart Road
Whitehall, PA 18052
|
|
|
|
|
American Fence provides commercial and residential sales, service, and installation for fencing such as wood fence, post & rail fence, ornamental fence, vinyl fence, and chain link fence, as well as dog kennels, railings & decking, gazebos, pergolas, sheds, ponds, automated gate access system, indoor storage cages, and perimeter security solutions in the following locations: Alburtis, Allen Township, Allentown, Bangor, Bath, Bethlehem, Bushkill Township, Catasauqua, Chestnut Hill Township, College Hill, Coopersburg, Coplay, East Allen Township, Easton, Emmaus, Forks Township, Fountain Hill, Freemansburg, Hanover Township, Hellertown, Lehigh County, Lehigh Township, Lehigh Valley, Lower Macungie Township, Lower Mt. Bethel Township, Lower Nazareth, Lower Nazareth Township, Lower Saucon, Lower Saucon Township, Macungie, Moore Township, Nazareth, North Catasauqua, North Whitehall, Northampton County, Palmer, Palmer Township, Pen Argyl, Plainfield Township, Roseto, Salisbury, Saucon Valley, Slatington, South Whitehall, Stewartsville, Stockertown, Tatamy, Trexlertown, Upper Macungie, Upper Nazareth, Upper Nazareth Township, Upper Saucon, Walnutport, West Easton, Whitehall, Williams Township, Wilson Borough, Wilson, Wind Gap and surrounding areas!
|
|
